| LiveWeb - insert and view web pages real-time. |
|
Note: OfficeTips is moving to a new domain - http://www.skphub.com Use LiveWeb to insert web pages into a
PowerPoint slide and refresh the pages real-time during slide show. Display
web pages without ever leaving the confines of your PowerPoint slide show.
No coding required. LiveWeb works with documents off
your local drive too. You can specify relative paths. LiveWeb will also
look for files in the presentation folder if the files have local drive
information and cannot be located at the location specified by the user
during slideshow. LiveWeb encapsulates the need to insert a web browser
control manually and write code to update the web pages within the control
during the slide show. It consists of two components. New in version 4.0 for PPT 2007 and later - Set the zoom level on the browser page. - Scripting error suppression. To purchase the source code for LiveWeb for commerical branding email . |
If you enjoy using my free addins, consider donating. Donations help keep the new add-ins, updates coming and help pay for the time spent maintaining and improving the software. Donations are entirely voluntary. But every donation is greatly appreciated. |
|
Store and operate the device within the specified temperature and humidity limits to prevent internal condensation or damage to plastic components. 3. User Interface & Basic Operation
By default, the display shows the temperature from the primary probe (B1). Changing the Set Point: Press the SET button briefly. Use the UP and DOWN arrows to adjust the desired value. Press SET again to confirm and save.
After modifying values with the arrows, you must press SET for at least 3 seconds to definitively save the new settings. If no button is pressed for 60 seconds, the device will exit without saving (timeout). Installation manual - Tempatron carel ritcusrg02 manual
Correct installation is critical to prevent electromagnetic interference and hardware failure.
Avoid installing probe cables near contactors or circuit breakers. If extension is needed, use cables with a minimum cross-section of 0.5 mm² . Store and operate the device within the specified
Front panel protection is rated up to IP55 , making it suitable for environments with moderate moisture. 2. Installation Best Practices
If prompted for a password (), the default is typically 22 for configuration access. Changing the Set Point: Press the SET button briefly
Monitors and controls temperatures from -50 °C to +150 °C .
The controller features a bright and a simple keypad for adjustments.
Copyright 1999-2016 (c) Shyam Pillai. All rights reserved.