Gemel Txshs User Manual -

The turn indicators will flash three times, and the alarm tone will sound three times to confirm the motion sensor is off.

Press both Button 1 and Button 2 simultaneously. Hold them for approximately 10 seconds until the LED on the remote stops flashing. Gemel Txshs User Manual

Turn the ignition OFF . Test the remote by arming and disarming the bike. Maintenance: Battery Replacement The Gemel TXSHS uses a CR 2032 3V lithium battery. The turn indicators will flash three times, and

Ensure the remote is within the motorcycle's reception range. Turn the ignition key to the ON position. Turn the ignition OFF

Release both buttons. The LED should now stay on. Press either Button 1 or Button 2 once. The LED should turn off.

If your remote stops responding (often after a battery change or if buttons were pressed over 256 times out of range), use this procedure to re-pair it:

The turn indicators will flash three times, and the alarm tone will sound three times to confirm the motion sensor is off.

Press both Button 1 and Button 2 simultaneously. Hold them for approximately 10 seconds until the LED on the remote stops flashing.

Turn the ignition OFF . Test the remote by arming and disarming the bike. Maintenance: Battery Replacement The Gemel TXSHS uses a CR 2032 3V lithium battery.

Ensure the remote is within the motorcycle's reception range. Turn the ignition key to the ON position.

Release both buttons. The LED should now stay on. Press either Button 1 or Button 2 once. The LED should turn off.

If your remote stops responding (often after a battery change or if buttons were pressed over 256 times out of range), use this procedure to re-pair it: