Hxc-fw-installer.hex May 2026

Connect the drive to your computer using your chosen cable.

Depending on the drive model, you may need a USB-A to USB-A cable or a USB-to-Serial (TTL) adapter . Hxc-fw-installer.hex

An STM32 or Artery AT32-based Gotek drive or clone. Connect the drive to your computer using your chosen cable

For many drives, you must place a jumper on the BOOT0 pins to put the device into programming mode. Hxc-fw-installer.hex

To use the hxc-fw-installer.hex file, you typically need the following:

Open your programming utility (e.g., Artery ISP Programmer) and select the correct port (often USB DFU ).

You must often disable flash protection and erase the original factory firmware before adding and flashing the hxc-fw-installer.hex file.