Lenel Lnl-3300-m5 Installation Manual Upd -

OnGuard software must be licensed and configured for the LNL-3300 series.

The board is designed to retrofit into legacy CASI M5/M3000 enclosures.

Legacy CASI M Series boards cannot be mixed with Lenel M Series boards in the same controller; if you convert a controller, all boards within it must be upgraded to the Lenel M Series. 2. Physical Installation Steps To install or migrate to the LNL-3300-M5 Lenel Lnl-3300-m5 Installation Manual UPD

: Mount the new board onto the existing standoffs in the enclosure.

A standard Cat5/6 cable for Ethernet and shielded twisted pair (24 AWG) for RS-485 downstream communication. OnGuard software must be licensed and configured for

Plug in the 12 VDC power input, cabinet tamper input, and AC power fail inputs. The LNL-3300-M5 is one-for-one plug compatible with these connections. 3. Initial Configuration & IP Setup LNL-3300-M5 - Stebilex Systems

is an Intelligent System Controller (ISC) designed specifically for the system. It serves as a plug-compatible, Mercury-based hardware replacement for legacy CASI M5 and M3000 boards , facilitating a modern migration path for systems like Picture Perfect , FCWnx , and Secure Perfect . 1. Pre-Installation Preparation Plug in the 12 VDC power input, cabinet

Before beginning, ensure you have the following requirements and tools: 12 VDC ± 10% at approximately 300mA.

Label and unplug the field wiring and the power/comm board connectors from the legacy CPU.

Completely power down the legacy controller and disconnect the backup battery.