| Fetchmail | 2026-05-08 |
: Tap the screen one last time anywhere to save the data and exit to the main operation interface. Alternative Calibration Methods
: Watch the screen as it boots. When the "Start" prompt or progress bar appears, tap the screen anywhere using your finger or a stylus.
You should initiate a calibration procedure if you notice the following issues: mcgs hmi touch calibration
: If the touch is so poorly aligned that you cannot tap the initial prompt, connect a USB mouse to the HMI's USB port to navigate the system settings.
: Once you have tapped the screen, wait approximately 30 seconds . The system will automatically enter the touch screen calibration utility. 2. Executing the Calibration : Tap the screen one last time anywhere
If the standard boot method is inaccessible, consider these alternatives:
: A small crosshair cursor ("+") will appear on the screen. You should initiate a calibration procedure if you
: Turn off the power to the HMI and then turn it back on.
: The cursor will move to several points (usually 4 or 5 positions). Repeat the tapping process for each new location.
Most modern MCGS TPC series devices follow a built-in startup routine to access calibration settings. 1. Entering the Boot Setup Interface