Ts1162 Installation Manual Exclusive Here

Once hardware is installed, the RAS must be identified by the Challenger panel.

: Use the base of the TS1162 or the provided gasket as a template to mark the four mounting hole locations.

The TS1162 is built for longevity, but for high-traffic areas, components like the front label may wear. Genuine replacement labels are available to maintain the professional appearance and legibility of the device. Tecom 3 LED RAS replacement label - GSA Systems ts1162 installation manual exclusive

: Features a dedicated Request to Exit (RTE) input and an open collector output for controlling door relays or strikes.

: Use the DIP switches or software configuration (depending on your specific panel version) to assign a unique address to the RAS. Once hardware is installed, the RAS must be

: Installation should be performed by trained security technicians. If electrical wiring for a power outlet (GPO) is required, you must use a qualified electrician .

: Connect the D+ , D- , +12V , and 0V terminals to the corresponding terminals on the Challenger LAN bus. Genuine replacement labels are available to maintain the

: The open collector output can be wired to a door relay or strike. For high-draw strikes, ensure a separate power supply and flyback diode are used to protect the keypad circuit. Step 4: System Addressing and Programming

: Three status LEDs provide clear system arming and area status information. Step 1: Pre-Installation Requirements

: Log in to the Challenger Installer Menu (typically Menu + Installer Code + 19) to add and configure the new station.