V2ray Mikrotik !new! File

V2Ray relies on a config.json file. Since you cannot easily edit files inside a running container on MikroTik, you should host this file on the router's disk. Create a folder on your disk (e.g., disk1/v2ray/ ). Upload your config.json to this folder.

You will be prompted to press a physical button on the router or perform a power cycle within 5 minutes to confirm.

: /container/config/set registry-url=https://docker.io Create the Container :

After rebooting, verify support by checking if the /container menu is available. Step 2: Configure Networking for the Container

: Container support is not available on RouterOS v6.

Once the container is "running," you need to tell MikroTik which traffic should go through it. Policy-Based Routing (PBR)

You can use official images from Docker Hub, such as v2fly/v2fly-core .

MikroTik requires a manual "opt-in" to enable container functionality for security reasons. Open the Terminal in WinBox. Run the command: /system/device-mode/update container=yes .

You will be prompted to press a physical button on the router or perform a power cycle within 5 minutes to confirm.

: /container/config/set registry-url=https://docker.io Create the Container :

After rebooting, verify support by checking if the /container menu is available. Step 2: Configure Networking for the Container

: Container support is not available on RouterOS v6.

Once the container is "running," you need to tell MikroTik which traffic should go through it. Policy-Based Routing (PBR)

You can use official images from Docker Hub, such as v2fly/v2fly-core .

MikroTik requires a manual "opt-in" to enable container functionality for security reasons. Open the Terminal in WinBox. Run the command: /system/device-mode/update container=yes .