Xycd60 Manual 【480p】

Always ensure the input voltage matches the battery's requirements. The module is a switch, not a buck/boost converter.

The is a versatile digital battery charging and discharging controller module designed to manage battery health by preventing overcharging and over-discharging . It is commonly used in DIY electronics, solar power setups, and battery maintenance systems. Core Functionality

for about 3 seconds to enter the parameter setting interface. Short press SET to cycle through the parameters: UP : Upper limit voltage. dn : Lower limit voltage. OP : Conduction time (00:00 to 99:59, or "----" to disable). dOP : Delayed conduction time (0–999 seconds). FOP : Forced start time (0–10 seconds) in discharge mode. Use UP/DOWN buttons to adjust the values. Press and hold SET again to save and exit. Voltage Percentage Calculation xycd60 manual

Avoid running continuous loads right at the 10A limit to prevent the relay from overheating.

Percentage=Current Voltage−dnUP−dn×100%Percentage equals the fraction with numerator Current Voltage minus dn and denominator UP minus dn end-fraction cross 100 % Always ensure the input voltage matches the battery's

Long press the DOWN button to toggle the backlight sleep mode. "On" keeps the light on; "OFF" turns the light off after 5–10 minutes of inactivity. Safety Precautions

This mode is used to protect batteries from deep discharge. The module connects the load when the battery is full and disconnects it once the voltage hits a minimum threshold. Voltage ≥is greater than or equal to UP . Condition to Stop: Voltage ≤is less than or equal to dn . Setting Up the XY-CD60 Entering Setup It is commonly used in DIY electronics, solar

If OP is set, the relay will automatically disconnect after the specified duration, even if the voltage threshold hasn't been reached. This acts as a safety backup.